Specifications 
Power output: 80 Watts RMS into 8 Ohm load
Power @ clipping (typical): 80 Watts RMS (7% THD, 1kHz)
Frequency Response: 20Hz - 20kHz +0, -1dB
Total Harmonic Distortion: < 0.5% @ 65W RMS, typically <0.2%
Hum & Noise: > -80dB below rated power
Power consumption: 200W 50/60Hz
Mains power: 230VAC
Dimensions: 520(w)x470(h)x280(d)

Pre-amp section:
The following specs are measured at 1kHz with the controls preset as follows: Push Bright: Off (out), channel select normal (out), Low & High @ 10, Mid @ 0, Presence @ 0dB, SuperSat® & post gain @ 10, Bottom, Body, Edge @ 0dB, Gain & Shift off (out), Normal levels are with gain @ 5.

Pre-amp High Gain Input:
Impedance: High Z, 220k Ohms
Nominal input level: -16dBV, 150mV RMS
Minimum input level: -34dBV, 20mV RMS
Maximum input level: +16dBV, 6V RMS

Effects send
Load impedance: >1k Ohms
Nominal Out put level: -10dBV, 0.3V RMS

Effects Return
Impedance: High Z, 22k Ohms
Designed input level: -10dBV, 0.3V RMS
(switching jack providing effects send to effects return connection when not used)

Preamp Output
Load impedance: >1k Ohms
Nominal output level: 0dBV, 1V RMS

Power Amp Input
Impedance: High Z, 30k Ohms
Designed input level: 0dBV, 1V RMS
(switching jack providing effects send to effects return connection when not used)

System Hum & Noise @ nominal input level
(20Hz - 20kHz unweighted)
745dB below rated power

Equalization (Normal channel only)
Special low, mid & high passive type EQ
Presence: ±-15dB @ 5kHz, shelving (active)
Push Bright: +6dB @ 2kHz

Voicing
Special bottom, body & edge active type EQ
Push shift: shifts body effect
Push Gain: Increases SuperSat® gain

External Footswitch function
Reverb defeat (when reverb control is raised)
Lead channel defeat (when selected with button) 

Price to rent         Price to buy